IBM R30 Operator's Manual page 164

General Attributes Always Required
The following general attributes are the default settings for the diagnostic programs. Be sure
your terminal is set to these attributes.
Note: These attributes should be set before the diagnostic programs are loaded.
Refer to the following table.
General
Setup
Attributes
Machine
mode
Generated
Code Set
Screen
Row and
Column
Scroll
Auto LF
CRT saver
Line wrap
Forcing
insert
8-4
Operator Guide
3151 3151
/11/31/41 /51/61 3161/3164
Settings Settings Settings
IBM 3151 IBM IBM 3161
3151 PC or
IBM 3164
ASCII
Normal Normal
24 x 80 24 x 80
Jump Jump Jump
Off Off Off
Off Off 10
On On On
Off Off
Description
The diagnostic programs are set to
emulate use of the 3161 ASCII
Display Terminal. If your terminal can
emulate a 5085, 3161 or 3164
terminal, use the following attribute
settings. Otherwise, refer to your
operator's manual, compare the
following attribute descriptions with
those of your terminal, and set your
attributes accordingly.
Uses the EIA-232 interface protocol.
Uses the EIA-232 interface protocol.
When the last character on the bottom
line is entered, the screen moves
down one line.
For the "On" setting, pressing the
Return key moves the cursor to the
first character position of the next line.
For the "Off" setting, pressing the
Return key moves the cursor to the
first character position of the current
line. The CR and LF characters are
generated by the New line setting.
The "10" setting causes the display
screen to go blank if there is no
activity for 10 minutes. When the
system unit sends data or a key is
pressed, the display screen contents
are displayed again.
The cursor moves to the first
character position of the next line in
the page after it reaches the last
character position of the current line in
the page.