Figure 54: Enabling Lacp On A Port; Figure 55: Configuring Lacp Parameters On A Port - Edge-Core ECS4620-28T Quick Start Manual

Chapter 4
| Interface Configuration
Trunk Configuration

Figure 54: Enabling LACP on a Port

To configure LACP parameters for group members:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Aggregation Port from the Step list.
3.
Select Configure from the Action list.
4.
Click Actor or Partner.
5.
Configure the required settings.
6.
Click Apply.

Figure 55: Configuring LACP Parameters on a Port

To show the active members of a dynamic trunk:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Trunk from the Step list.
3.
Select Show Member from the Action list.
– 146 –