Edge-Core ECS4620-28T Quick Start Manual page 969

General Commands
boot system
This command specifies the file or image used to start up the system.
Syntax
boot system [unit:] {boot-rom | config | opcode}: filename
unit* - Unit identifier. (Range: 1-8)
boot-rom* - Boot ROM.
config* - Configuration file.
opcode* - Run-time operation code.
filename - Name of configuration file or code image.
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆
A colon (:) is required after the specified unit number and file type.
◆
If the file contains an error, it cannot be set as the default file.
Example
Console(config)#boot system config: startup
Console(config)#
Related Commands
dir (144)
whichboot (145)
Chapter 4
– 139 –
| System Management Commands
File Management