Figure 402: Send Dhcp Inform Requests For Additional Information - Edge-Core ECS4620-28T Quick Start Manual

Chapter 15
| IP Configuration
Setting the Switch's IP Address (IP Version 6)
Setting the Switch's IP Address (IP Version 6)
Web Interface
To send DHCP Inform requests for additional information:
1.
Click IP, General, Routing Interface.
2.
Select Configure Interface from the Action list.
3.
Select a VLAN configured with a static IPv4 address.
4.
Set the DHCP inform field to the required status.
5.
Click Apply.

Figure 402: Send DHCP Inform Requests for Additional Information

This section describes how to configure an IPv6 interface for management access
over the network, or for creating an interface to multiple subnets. This switch
supports both IPv4 and IPv6, and can be managed through either of these address
types. For information on configuring the switch with an IPv4 address, see
the Switch's IP Address (IP Version 4)" on page
Command Usage
◆
IPv6 includes two distinct address types – link-local unicast and global unicast.
A link-local address makes the switch accessible over IPv6 for all devices
attached to the same local subnet. Management traffic using this kind of
address cannot be passed by any router outside of the subnet. A link-local
address is easy to set up, and may be useful for simple networks or basic
troubleshooting tasks. However, to connect to a larger network with multiple
segments, the switch must be configured with a global unicast address. A link-
local address can be dynamically assigned (using the Configure Interface page)
or manually configured (using the Add IPv6 Address page). A global unicast
address can only be manually configured on this router (using the Add IPv6
Address page).
◆
An IPv6 global unicast or link-local address can be manually configured (using
the Add IPv6 Address page), or a link-local address can be dynamically
generated (using the Configure Interface page).
619.
– 624 –
"Setting