Figure 467: Adding Network Interfaces To Rip - Edge-Core ECS4620-28T Quick Start Manual

Chapter 19
| Unicast Routing
Configuring the Routing Information Protocol
Parameters
These parameters are displayed:
◆
By Address – Adds a network to the RIP routing process.
Subnet Address – IP address of a network directly connected to this router.
■
(Default: No networks are specified)
Prefix Length – A decimal value indicating how many contiguous bits
■
(from the left) of the address comprise the network portion of the address.
This mask identifies the network address bits used for the associated
routing entries.
◆
By VLAN – Adds a Layer 3 VLAN to the RIP routing process. The VLAN must be
configured with an IP address. (Range: 1-4094)
Web Interface
To add a network interface to RIP:
1.
Click Routing Protocol, RIP, Network.
2.
Select Add from the Action list.
3.
Add an interface that will participate in RIP.
4.
Click Apply.

Figure 467: Adding Network Interfaces to RIP

To show the network interfaces using RIP:
1.
Click Routing Protocol, RIP, Network.
2.
Select Show from the Action list.
3.
Click IP Address or VLAN.
– 704 –