Figure 117: Configuring Interface Settings For Sta - Edge-Core ECS4620-28T Quick Start Manual

Displaying Interface Settings for STA

Figure 117: Configuring Interface Settings for STA

Use the Spanning Tree > STA (Configure Interface - Show Information) page to
display the current status of ports or trunks in the Spanning Tree.
Parameters
These parameters are displayed:
◆
Spanning Tree – Shows if STA has been enabled on this interface.
◆
BPDU Flooding – Shows if BPDUs will be flooded to other ports when
spanning tree is disabled globally on the switch or disabled on a specific port.
◆
STA Status – Displays current state of this port within the Spanning Tree:
Discarding - Port receives STA configuration messages, but does not
■
forward packets.
■ Learning - Port has transmitted configuration messages for an interval set
by the Forward Delay parameter without receiving contradictory
information. Port address table is cleared, and the port begins learning
addresses.
Forwarding - Port forwards packets, and continues learning addresses.
■
Chapter 7
– 221 –
| Spanning Tree Algorithm
Displaying Interface Settings for STA