Figure 264: Setting Community Access Strings; Figure 265: Showing Community Access Strings - Edge-Core ECS4620-28T Quick Start Manual

Chapter 13
| Basic Administration Protocols
Simple Network Management Protocol
Web Interface
To set a community access string:
1.
Click Administration, SNMP.
2.
Select Configure User from the Step list.
3.
Select Add Community from the Action list.
4.
Add new community strings as required, and select the corresponding access
rights from the Access Mode list.
5.
Click Apply

Figure 264: Setting Community Access Strings

To show the community access strings:
1.
Click Administration, SNMP.
2.
Select Configure User from the Step list.
3.
Select Show Community from the Action list.

Figure 265: Showing Community Access Strings

– 434 –