Figure 438: Configuring Interface Settings For Pppoe Intermediate Agent; Showing Pppoe Ia Statistics - Edge-Core ECS4620-28T Quick Start Manual

28/52-port l3 stackable gigabit ethernet switch

Hide thumbs Also See for ECS4620-28T:

Table of Contents

| IP Services

Configuring the PPPoE Intermediate Agent

Showing PPPoE IA

Remote ID – String identifying the remote identifier (or interface) on this

switch to which the user is connected. (Range: 1-63 ASCII characters;

Default: Port MAC address)

Operational Remote ID – The configured circuit identifier.

Web Interface

To configure interface settings for PPPoE IA:

Click IP Service, PPPoE Intermediate Agent.

Select Configure Interface from the Step list.

Select Port or Trunk interface type.

Enable PPPoE IA on an interface, set trust status, enable vendor tag stripping if

required, and set the circuit ID and remote ID.

Click Apply.

Figure 438: Configuring Interface Settings for PPPoE Intermediate Agent

Use the IP Service > PPPoE Intermediate Agent (Show Statistics) page to show

statistics on PPPoE IA protocol messages.

These parameters are displayed:

Interface – Port or trunk selection.

Received – Received PPPoE active discovery messages.

All – All PPPoE active discovery message types.

PADI – PPPoE Active Discovery Initiation messages.

Show Quick Links

Table of Contents