Figure 330: Displaying Status Of Remote Interfaces; Configuring A Remote Loopback Test - Edge-Core ECS4620-28T Quick Start Manual

28/52-port l3 stackable gigabit ethernet switch

Hide thumbs Also See for ECS4620-28T:

Table of Contents

| Basic Administration Protocols

OAM Configuration

Configuring a Remote

Loopback Test

Web Interface

To display information about attached OAM-enabled devices:

Click Administration, OAM, Remote Interface.

Figure 330: Displaying Status of Remote Interfaces

Use the Administration > OAM > Remote Loopback (Remote Loopback Test) page

to initiate a loop back test to the peer device attached to the selected port.

Command Usage

You can use this command to perform an OAM remote loop back test on the

specified port. The port that you specify to run this test must be connected to a

peer OAM device capable of entering into OAM remote loop back mode.

During a remote loop back test, the remote OAM entity loops back every frame

except for OAMPDUs and pause frames.

OAM remote loopback can be used for fault localization and link performance

testing. Statistics from both the local and remote DTE can be queried and

compared at any time during loop back testing.

To perform a loopback test, first enable Remote Loop Back Mode, click Test, and

then click End. The number of packets transmitted and received will be

These parameters are displayed:

Loopback Mode of Remote Device

Port – Port identifier. (Range: 1-28/52)

Loopback Mode – Shows if loop back mode is enabled on the peer. This

attribute must be enabled before starting the loopback test.

Show Quick Links

Table of Contents