Figure 426: Configuring Excluded Addresses On The Dhcp Server - Edge-Core ECS4620-28T Quick Start Manual

Chapter 16
| IP Services
Dynamic Host Configuration Protocol
Setting Excluded Addresses
Use the IP Service > DHCP > Server (Configure Excluded Addresses – Add) page to
specify the IP addresses that should not be assigned to clients.
Parameters
These parameters are displayed:
◆
Start IP Address – Specifies a single IP address or the first address in a range
that the DHCP server should not assign to DHCP clients.
◆
End IP Address – The last address in a range that the DHCP server should not
assign to DHCP clients.
Note: Be sure you exclude the address for this switch and other key network
devices.
Web Interface
To configure IP addresses excluded for DHCP clients:
1.
Click IP Service, DHCP, Server.
2.
Select Configure Excluded Addresses from the Step list.
3.
Select Add from the Action list.
4.
Enter a single address or an address range.
5.
Click Apply.

Figure 426: Configuring Excluded Addresses on the DHCP Server

To show the IP addresses excluded for DHCP clients:
1.
Click IP Service, DHCP, Server.
2.
Select Configure Excluded Addresses from the Step list.
3.
Select Show from the Action list.
– 654 –