Figure 342: Showing Static Interfaces Assigned To A Multicast Service; Setting Igmp Snooping Status Per Interface - Edge-Core ECS4620-28T Quick Start Manual

Chapter 14
| Multicast Filtering
Layer 2 IGMP (Snooping and Query for IPv4)
Setting IGMP
Snooping Status
per Interface
To show the static interfaces assigned to a multicast service:
1.
Click Multicast, IGMP Snooping, IGMP Member.
2.
Select Show Static Member from the Action list.
3.
Select the VLAN for which to display this information.

Figure 342: Showing Static Interfaces Assigned to a Multicast Service

Use the Multicast > IGMP Snooping > Interface (Configure VLAN) page to configure
IGMP snooping attributes for a VLAN. To configure snooping globally, refer to
"Configuring IGMP Snooping and Query Parameters" on page
Command Usage
Multicast Router Discovery
There have been many mechanisms used in the past to identify multicast routers.
This has lead to interoperability issues between multicast routers and snooping
switches from different vendors. In response to this problem, the Multicast Router
Discovery (MRD) protocol has been developed for use by IGMP snooping and
multicast routing devices. MRD is used to discover which interfaces are attached to
multicast routers, allowing IGMP-enabled devices to determine where to send
multicast source and group membership messages. (MRD is specified in draft-ietf-
magma-mrdisc-07.)
Multicast source data and group membership reports must be received by all
multicast routers on a segment. Using the group membership protocol query
messages to discover multicast routers is insufficient due to query suppression.
MRD therefore provides a standardized way to identify multicast routers without
relying on any particular multicast routing protocol.
– 550 –
542.