Figure 399: Configuring A Static Ipv4 Address - Edge-Core ECS4620-28T Quick Start Manual

Web Interface
To set a static IPv4 address for the switch:
1.
Click IP, General, Routing Interface.
2.
Select Add Address from the Action list.
3.
Select any configured VLAN, set IP Address Mode to "User Specified, " set IP
Address Type to "Primary" if no address has yet been configured for this
interface, and then enter the IP address and subnet mask.
4.
Click Apply.

Figure 399: Configuring a Static IPv4 Address

To obtain an dynamic IPv4 address through DHCP/BOOTP for the switch:
1.
Click IP, General, Routing Interface.
2.
Select Add Address from the Action list.
3.
Select any configured VLAN, and set IP Address Mode to "BOOTP" or "DHCP. "
4.
Click Apply to save your changes.
5.
Then click Restart DHCP to immediately request a new address.
IP will be enabled but will not function until a BOOTP or DHCP reply is received.
Requests are broadcast every few minutes using exponential backoff until IP
configuration information is obtained from a BOOTP or DHCP server.
Setting the Switch's IP Address (IP Version 4)
– 621 –
Chapter 15
| IP Configuration