Edge-Core ECS4620-28T Quick Start Manual page 905

28/52-port l3 stackable gigabit ethernet switch
Hide thumbs Also See for ECS4620-28T:
Table of Contents

Advertisement

To generate an IPv6 global unicast address for the switch, complete the following
steps:
1.
From the global configuration mode prompt, type "interface vlan 1" to access
the interface-configuration mode. Press <Enter>.
2.
From the interface prompt, type "ipv6 address ipv6-address" or "ipv6 address
ipv6-address/prefix-length, " where "prefix-length" indicates the address bits
used to form the network portion of the address. (The network address starts
from the left of the prefix and should encompass some of the ipv6-address
bits.) The remaining bits are assigned to the host interface. Press <Enter>.
3.
Type "exit" to return to the global configuration mode prompt. Press <Enter>.
4.
To set the IP address of the IPv6 default gateway for the network to which the
switch belongs, type "ipv6 default-gateway gateway, " where "gateway" is the
IPv6 address of the default gateway. Press <Enter>.
Console(config)#interface vlan 1
Console(config-if)#ipv6 address 2001:DB8:2222:7272::/64
Console(config-if)#exit
Console(config)#ipv6 default-gateway 2001:DB8:2222:7272::254
Console(config)end
Console#show ipv6 interface
VLAN 1 is up
IPv6 is enabled.
Link-local address:
fe80::200:e8ff:fe94:4000%1/64
Global unicast address(es):
2001:db8:2222:7272::/64, subnet is 2001:db8:2222:7272::/64
Joined group address(es):
ff02::1:ff00:0
ff02::1:ff94:4000
ff02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 3.
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised router lifetime is 1800 seconds
Console#show ipv6 route
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
* - candidate default
S*
::/0 [1/0] via 2001:db8:2222:7272::254, VLAN1
C
2001:db8:2222:7272::/64, VLAN1
C
fe80::/64, VLAN1
Console#
Chapter 1
Configuring the Switch for Remote Management
– 75 –
| Initial Switch Configuration

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents