Figure 534: Enabling Pimv6 Multicast Routing; Configuring Pimv6 For Ipv6 - Edge-Core ECS4620-28T Quick Start Manual

Configuring PIMv6 for IPv6

Enabling
PIMv6 Globally
Configuring PIMv6
Interface Settings
This section describes how to configure PIM-DM and PIM-SM for IPv6.
Use the Routing Protocol > PIM6 > General page to enable IPv6 PIM routing
globally on the router.
Command Usage
◆
This feature enables PIM-DM and PIM-SM for IPv6 globally on the router. You
also need to enable PIM-DM and PIM-SM for each interface that will support
multicast routing (see
multicast protocol parameters.
◆
To use PIMv6, multicast routing must be enabled on the switch (see
Multicast Routing Globally" on page
◆
To use multicast routing, MLD proxy cannot be enabled on any interface of the
device (see "MLD Proxy Routing" in the CLI Reference Guide).
Web Interface
To enable PIMv6 multicast routing:
1.
Click Routing Protocol, PIM6, General.
2.
Enable PIM6 Routing Protocol.
3.
Click Apply.

Figure 534: Enabling PIMv6 Multicast Routing

Use the Routing Protocol > PIM6 > Interface page configure the routing protocol's
functional attributes for each interface.
Command Usage
◆
Most of the attributes on this page are common to both PIM6-DM and
PIM6-SM. Select Dense or Sparse Mode to display the common attributes, as
well as those applicable to the selected mode.
◆
An IPv6 address must first be assigned to the required routing interface before
PIMv6 can be configured on this page.
page 775), and make any changes necessary to the
754).
– 775 –
Chapter 20
| Multicast Routing
Configuring PIMv6 for IPv6
"Enabling