Figure 380: Assigning Static Mvr Groups To An Interface - Edge-Core ECS4620-28T Quick Start Manual

Parameters
These parameters are displayed:
◆
Domain ID – An independent multicast domain. (Range: 1-5)
◆
Interface – Port or trunk identifier.
◆
VLAN – VLAN identifier. (Range: 1-4094)
◆
Group IP Address – Defines a multicast service sent to the selected port.
Multicast groups must be assigned from the MVR group range configured on
the Configure General page.
Web Interface
To assign a static MVR group to an interface:
1.
Click Multicast, MVR.
2.
Select Configure Static Group Member from the Step list.
3.
Select Add from the Action list.
4.
Select an MVR domain.
5.
Select a VLAN and interface to receive the multicast stream, and then enter the
multicast group address.
6.
Click Apply.

Figure 380: Assigning Static MVR Groups to an Interface

To show the static MVR groups assigned to an interface:
1.
Click Multicast, MVR.
2.
Select Configure Static Group Member from the Step list.
3.
Select Show from the Action list.
– 595 –
Chapter 14
| Multicast Filtering
Multicast VLAN Registration for IPv4