Figure 374: Configuring Domain Settings For Mvr - Edge-Core ECS4620-28T Quick Start Manual

4.
5.

Figure 374: Configuring Domain Settings for MVR

Configuring
Use the Multicast > MVR (Configure Profile and Associate Profile) pages to assign
MVR Group the multicast group address for required services to one or more MVR domains.
Address Profiles
Command Usage
◆
◆
◆
Parameters
These parameters are displayed:
Configure Profile
◆
◆
Enable MVR for the selected domain, select the MVR VLAN, set the forwarding
priority to be assigned to all ingress multicast traffic, and set the source IP
address for all control packets sent upstream as required.
Click Apply.
Use the Configure Profile page to statically configure all multicast group
addresses that will join the MVR VLAN. Any multicast data associated with an
MVR group is sent from all source ports to all receiver ports that have registered
to receive data from that multicast group.
The IP address range from 224.0.0.0 to 239.255.255.255 is used for multicast
streams. MVR group addresses cannot fall within the reserved IP multicast
address range of 224.0.0.x.
IGMP snooping and MVR share a maximum number of 1024 groups. Any
multicast streams received in excess of this limitation will be flooded to all ports
in the associated domain.
Profile Name – The name of a profile containing one or more MVR group
addresses. (Range: 1-21 characters)
Start IP Address – Starting IP address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
– 589 –
Chapter 14
| Multicast Filtering
Multicast VLAN Registration for IPv4