Figure 240: Configuring Smtp Alert Messages - Edge-Core ECS4620-28T Quick Start Manual

Chapter 13
| Basic Administration Protocols
Configuring Event Logging
◆
Email Destination Address – Specifies the email recipients of alert messages.
You can specify up to five recipients.
◆
Server IP Address – Specifies a list of up to three recipient SMTP servers. IPv4
or IPv6 addresses may be specified. The switch attempts to connect to the
listed servers in sequential order if the first server fails to respond.
For host name-to-IP address translation to function properly, host name lookup
must be enabled ("Configuring General DNS Service Parameters" on page
and one or more DNS servers specified (see
Servers" on page 646, or
page 647).
Web Interface
To configure SMTP alert messages:
1.
Click Administration, Log, SMTP.
2.
Enable SMTP, specify a source email address, and select the minimum severity
level. Specify the source and destination email addresses, and one or more
SMTP servers.
3.
Click Apply.

Figure 240: Configuring SMTP Alert Messages

"Configuring Static DNS Host to Address Entries" on
– 394 –
"Configuring a List of Name
643),