Winding Up The Media Strip In Rewind Mode - QuickLabel QL-60 User Manual

Loading Media

Winding up the Media Strip in Rewind Mode

Figure 9: Guiding the media strip in rewind mode
In rewind mode, the labels are wound up internally after printing for later use.
1
2
3
4
5
6
7
40
1
2
3
Install rewind guide plate.
Plate or Tear-off Plate" on page 46.
Lift the pinch roller (3) off the rewind assist roller.
Guide label strip around the rewind guide plate (2) to the internal rewinder (6).
Hold rewinder (6) firmly and turn knob (5) clockwise until it stops.
Push label strip under a bracket (4) of the rewinder and turn knob (5) counterclockwise until
it stops. The rewinder is fully spread, thus gripping the label strip firmly.
Turn rewinder (6) counterclockwise to tighten the label strip.
Turn lever (1) clockwise to lock the printhead.
The label roll is loaded for use in rewind mode.
4 5 6
See "Removing and Installing the Rewind Guide Plate, Dispense
7
QL-30/60 User Guide