Peeling-Off On Demand Without Present Sensor - QuickLabel QL-60 User Manual

Peeling-off on Demand without Present Sensor

In the peel-off mode with PS800 or PS900 the label removal from the peel position is detected
by an optical sensor.
Using the I/O interface the label removal can be confirmed by the external signal LBLREM. That
way it is possible to operate the printer in peel-off mode without present sensor.
Starting Print and Confirming Label Removal with Two Signals
Requirements:
•
•
•
•
Operation:
1) Send a print job.
2) Activate START.
3) Remove the label.
4) Confirm the label removal with signal LBLREM.
QL-30/60 User Guide
Operation without present sensor.
External circuit as shown in Figure 51 / Figure 52
Setting Printing > Print on Demand = "On".
Setting Interfaces > I/O > Automatic LBLREM = "Off"
The first label will be printed an transported to the peel position.
I/O Interface
133