Setting The Head Locking System; Ql-30, Ql-60, Ql-30P, Ql-60P - QuickLabel QL-60 User Manual

Loading Media
9
10

Setting the Head Locking System

QL-30, QL-60, QL-30P, QL-60P

The printhead is pushed on via two plungers. The location of the outer plunger must be set to
the width of the label medium used so as to:
•
•
•
Figure 13: Setting the head locking system
•
•
•
•
44
Set the head locking system.
Turn lever (6) clockwise to lock the printhead.
achieve even print quality across the entire label width
prevent wrinkles in the feed path of the transfer ribbon
prevent premature wearing of the print roller and printhead.
1
Loosen threaded pin (3) at outer plunger (1) with Allen key.
Turn lever (2) clockwise to lock the printhead.
Position outer plunger (1) over the outer media edge.
Tighten threaded pin (3).
See "Setting the Head Locking System" on page 44.
2 3
QL-30/60 User Guide