Event Log - QuickLabel QL-60 User Manual

Diagnostic Functions
Table 41: Information in Label profile
1
2
3
4
5

Event Log

The label printer saves the following events in the Event log:
•
•
•
•
•
The printout occurs using the heat level and print speed specified in the Setup > Printing menu.
Note: The printout occurs without taking the label gaps into consideration. This is why
continuous media is most suitable for this purpose.
1) Insert printable medium (labels, continuous media) which extends across the entire printing
2) If the printout is to occur using thermal transfer printing, insert transfer ribbon with the
3) Start menu.
114
#
Date and time of the printout
Device type
Version and creation date of the firmware
Serial number of the PCB CPU
Firmware version and serial number of the label sensor
Coordinate in the direction of media flow at which the label start was
detected
Type of peripheral device connected
Print speed, method of label detection (Gap sensor / Bottom-reflect
sensor)
Brightness of the sensor LED during the measurement
Average value and variation of label distances
Hardware fault
Printhead replacement
Firmware updates
Changing the OEM name
Resetting of the service counters
width.
maximum width.
Description
QL-30/60 User Guide