Peeling-Off; Labeling - QuickLabel QL-60 User Manual

Peeling-off

Note: If peel-off module is not installed, access only with service key inserted.
•
•
Table 25: Parameters of the Setup > Peeling-off menu

Labeling

Note: If applicator is not installed, access only with service key inserted.
•
•
Table 26: Parameters of the Setup > Labeling menu
QL-30/60 User Guide
Start menu.
Select Setup > Peeling-off.
Icon Parameter
Peel-off position
Backfeed delay
Backfeed position
Start menu.
Select Setup > Labeling.
Icon Parameter
Transfer mode
Meaning
Shift the position of the dispensed label
relative to the dispensing edge.
The setting can also be adjusted by the
software.
The settings of configuration and
software are added together.
Delay time between removing the label
from the peel position and the backfeed
of the label.
Offset of the backfeed movement
Meaning
Setting the operation mode Stamp on,
Roll on, Blow on
Configuration
Default
0.0 mm
250 ms
1.0 mm
Default
Stamp on
85