Errors - QuickLabel QL-60 User Manual

Table 31: Parameters of the Setup > Interfaces > I/O menu (Continued)

Errors

•
•
Table 32: Parameters of the Setup > Errors menu
QL-30/60 User Guide
Icon Parameter
REPRINT mode
Automatic
LBLREM
Start menu.
Select Setup > Errors.
Icon Parameter
Error-Reprint
Syntax error
Meaning
Configuration of the I/O signal REPRINT
• Edge: A label will be repeated by
switching on 24V between REPRINT
and GND_EXT.
• Level: A label will be repeated as long
as 24V are switched on between
REPRINT and GND_EXT.
• START/REPRINT select: A label will
be repeated when 24V are switched
on between REPEAT and GND_EXT
and the START signal will be
activated additionally.
Simulation of the I/O signal LBLREM
For peel-off mode without present
sensor
• On: With the signal START the
removing of the previous label also
will be confirmed.
• Off: To confirm the label removing the
signal LBLREM must be activated.
Meaning
• On: With a correctable error and
corresponding troubleshooting, the
label being printed when the error
occurs is repeated.
• Off: Print job is continued with the next
label.
Printer switches to error mode after
receipt of an incorrect command.
Configuration
Default
Edge
Off
Default
On
On
91