Table of Contents
Advertisement
Loading Media
4
5
6
Inserting the Media Strip into the Printhead
1
Figure 8: Inserting the media strip into the printhead
1
2
3
38
Load label roll (3) on the roll retainer in such a way that the labels can be inserted into the
printhead in the right position. The printing side of the labels must be visible from above.
•
QL-30, QL-60, QL-30P, QL-60P - Re-mount the margin stop (1) onto the roll retainer
(4). Push the margin stop (1) to the roll until the roll touches the chassis and the roll
retainer and a clear resistance is encountered.
•
QL-30M, QL-60M, QL-30MP, QL-60MP - Re-mount the margin stop (1) onto the roll
retainer (4). Push the margin stop (1) to the roll until the roll touches both roll retainers
and a clear resistance is encountered.
Turn ring (2) clockwise, so that the arrow (10) points to the lock symbol, and thus fix the
margin stop (1) on the roll retainer (4).
Supply longer label strips:
•
For Peel-Off or Rewind mode: approx. 60 cm
•
For Tear-Off mode: approx. 40 cm
2
3
4
5
6
Turn lever (2) counterclockwise to lift the printhead.
Adjust the guide(s) (6) with the knob (7) in such a way that:
•
QL-30, QL-60, QL-30P, QL-60P - the media can pass between the guide and the
chassis.
•
QL-30M, QL-60M, QL-30MP, QL-60MP - the media can pass between the two guides.
Guide label strip over the internal rewinder to the print unit.
10
7
9
1
2
3
8
4
5
6
QL-30/60 User Guide
7
Advertisement
Table of Contents
