Table of Contents
Advertisement
Table 11: Error Messages and Fault Correction (Continued)
No label found
No label size
Out of paper
Out of ribbon
Pinch roller open
Printhead open
QL-30/60 User Guide
Error message
Cause
There are labels missing on
the label material
The label format as set in
the software does not
correspond with the real
label format
Printer is loaded with
continuous paper, but the
software is set on labels
The size of the label is not
defined in the programming.
Out of label roll
Error in the paper feed
Out of transfer ribbon
Transfer ribbon melted
during printing
The printer is loaded with
thermal labels, but the
software is set to transfer
printing
Pinch roller at the rewind
guide roller is not locked in
peel-off mode
Printhead not locked
Fault Correction
Remedy
Press Repeat repeatedly
until printer recognizes the
next label on the material.
Cancel current print job.
Change the label format set
in the software.
Restart print job.
Cancel current print job.
Change the label format set
in the software.
Restart the print job.
Check programming.
Load labels.
Check paper feed.
Insert new transfer ribbon.
Cancel current print job.
Change the heat level via
software.
Clean the printhead.
See
"Cleaning the Printhead" on
page 51.
Load transfer ribbon.
Restart print job.
Cancel current print job.
Set software to direct
thermal printing.
Restart print job.
Swing the pinch roller
against the rewind assist
roller.
Lock printhead.
55
Advertisement
Table of Contents
