Loading Media
Winding up the Liner in Peel-Off mode
Figure 11: Guidance of the material in peel-off mode
In Peel-Off mode, the labels are removed after printing, and only the liner is wound up internally.
1
2
3
4
5
6
7
8
9
10
42
1
2
3
4
Lift the pinch roller (4) off the rewind assist roller (3).
Remove labels from the first 100 mm of the liner.
Guide liner to the rewinder (7) around the dispense plate (2) and the rewind assist roller (3).
Hold rewinder (7) firmly and turn knob (6) clockwise until it stops.
Push liner under a bracket (5) of the rewinder (7) and align the outer edge of the strip to the
media roll (8).
Turn knob (6) counterclockwise until it stops.
The rewinder is fully spread, thus gripping the liner firmly.
Turn rewinder (7) counterclockwise to tighten the liner.
Position the pinch roller (4) centrally to the liner.
Swing the pinch roller (4) against the rewind assist roller (3).
Turn lever (1) clockwise to lock the printhead.
The label roll is loaded for use in peel-off mode.
8
5
6 7
QL-30/60 User Guide