QuickLabel QL-60 User Manual page 137

Starting Print and Confirming Label Removal with Signal START
Requirements:
•
•
•
•
•
Operation:
1) Send a print job.
2) Activate START and hold it active.
3) Remove the label.
4) Confirm the label removal with deactivation of START.
QL-30/60 User Guide
Operation without present sensor.
External circuit as shown in Figure 55 / Figure 56
Setting Printing > Print on Demand = "On".
Setting Interfaces > I/O > START mode = "Level".
Setting Interfaces > I/O > Automatic LBLREM = "On".
The first label will be printed an transported to the peel position.
I/O Interface
137