Load Settings; Reset Settings - QuickLabel QL-60 User Manual

Extras
6) Confirm the selection. The .xml file will be stored in the folder /misc of the storage device.
An error message appearing during the saving procedure may be caused by an unreadable
medium (e.g. unknown medium, unformatted medium).

Load Settings

A printer configuration previously saved to a storage device can be loaded with the Load
settings function.
1) Start menu.
2) Select Extras.
3) Select Load settings.
4) Select the desired file.
5) Confirm the selection. Loading of the configuration data starts. Do not remove the USB
If an error occurs during the loading procedure, an error message appears in the display.
Restart the loading procedure in this case. If an error occurs again, the configuration
parameters must be entered via the control panel.

Reset Settings

With the Default settings function all setup parameters except the passwords can be reset to
the default values.
1) Start menu.
2) Select Extras.
3) Select Reset settings.
4) Select Continue. The setup parameters will be reset and the printer returns to the Extras
120
If the menu is protected via a PIN, a prompt appears in the display. Enter the code number
and confirm it.
flash drive until the loading procedure is complete. The printer returns to the Extras menu.
See "Security" on page 77.
If the menu is protected via a PIN, a prompt appears in the display. Enter the code number
and confirm it.
The display shows "Reset settings".
menu.
See "Format Storage" on page 148.
QL-30/60 User Guide