Connecting The Device; Connecting To The Power Supply; Connecting To A Computer Or Computer Network; Switching On The Device - QuickLabel QL-60 User Manual

Connecting the Device

The standard available interfaces and connectors are shown in Figure 3.

Connecting to the Power Supply

The printer is equipped with a wide area power unit. The device can be operated with a supply
voltage of 230 V~/50 Hz or 115 V~/60 Hz without adjustment.
1
2
3

Connecting to a Computer or Computer Network

Attention: Inadequate or no grounding can cause malfunctions during operations. Ensure that
all computers and cables connected to the label printer are grounded.
1

Switching on the Device

When all connections have been made:
1
QL-30/60 User Guide
Check that the device is switched off.
Plug the power cable into the power connection socket (28).
Plug the power cable into a grounded socket.
Connect the label printer to a computer or network by a suitable cable.
For details of the configuration of the individual interfaces, refer to
Printer to Computer" on page
Switch the printer on at the power switch (27).
The printer performs a system test, and then shows the system status Ready in the display
(10).
69.
Installation
"Connecting Label
23