Terminal Cover - YASKAWA U1000 Series Technical Manual

3.5 Terminal Cover

3.5 Terminal Cover
Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is
complete.
◆ 20028 to 20130, 40011 to 40124
Removing the Terminal Cover
■
1.
Loosen the terminal cover screw.
Figure 3.16
2.
Push in on the hook located on the bottom of the terminal cover, and gently pull forward. This should remove the
terminal cover.
Figure 3.17
■ Reattaching the Terminal Cover
Power lines and signal wiring should pass through the opening provided.
page 98 and Wiring the Control Circuit Terminal on page 106
Reattach the terminal cover after completing the wiring to the drive and other devices.
Figure 3.18
<1> Connect the ground wiring first, then the main circuit wiring, and finally the control circuit wiring.
84
Figure 3.15 Removing the Terminal Cover
Figure 3.16 Removing the Terminal Cover
<1>
Figure 3.17 Reattaching the Terminal Cover
Refer to Wiring the Main Circuit Terminal on
for details on wiring.
YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual