Terminal Cover - YASKAWA CIMR-DC4A0040AAA Technical Manual

3.5 Terminal Cover

3.5 Terminal Cover
Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is
complete.
◆ Models 2A0005 to 2A0020, 4A0005 to 4A0020 (IP20/Open Type Enclosure)
Removing the Terminal Cover
■
Loosen the terminal cover screw using a #2 Phillips screwdriver. Screw sizes vary by converter model.
Then, push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal
cover.
Figure 3.12
Figure 3.12 Removing the Terminal Cover on an IP20/Open Type Enclosure Model
Reattaching the Terminal Cover
■
Power lines and signal wiring should pass through the opening provided. Refer to
page 61 and Wiring the Control Circuit Terminal on page 72
Reattach the terminal cover after completing the wiring to the converter and other devices.
Figure 3.13
<1> Connect ground wiring first, followed by the main circuit, and then wire the control circuit. Power lines and signal wiring
exit through the opening provided.
Figure 3.13 Reattaching the Terminal Cover on an IP20/Open Type Enclosure Model
54
<1>
YASKAWA ELECTRIC SIEP C710656 06F YASKAWA Power Regenerative Converter - D1000 Technical Manual
Wiring the Main Circuit Terminal on
for details on wiring.