To Select Baud Rate; Figure ‎ 1 0-2 Pc - Lcr-6000 Series Connection Uses A Null Modem - Cubicon Lux User Manual

Figure ‎ 1 0-2

10.2 To Select Baud Rate

PC - LCR-6000 Series connection uses a null modem
connection
LCR
Pin2 RxD
Pin3 TxD
Pin5 GND
Make sure the controller you connect to LCR-6000

Series also uses these settings. The RS-232 interface
transfers data using:
8 data bits, 1 stop bit, no parity.
Before you can control the LCR-6000 Series by issuing
RS-232 commands from the built-in RS-232 controller
connected via its DB-9 connector, you have to configure
the RS-232 baud rate.
The LCR-6000 Series' built-in RS-232 interface uses the
SCPI language. The RS-232 configuration is as follows:
Data bits: 8-bit
Stop bits: 1-bit
Parity: none
To set up the baud rate
Step 1. Press the [Measure] or [Setup] key.
Step 2. Press the [SYSTEM] bottom soft-key.
Step 3. Use the cursor key to select the [BAUD] field.
Step 4. Use the soft-keys to select the baud rate.
Soft-key Function
1200 Sets the baud rate to 1200
9600 Sets the baud rate to 9600
38400 Sets the baud rate to 38400
57600 Sets the baud rate to 57600
115200 Sets the baud rate to 115200
LCR-6000 Series User Manual
PC
RxD Pin2
TxD Pin3
GND Pin5
91