4.3.3 List Measurement Parameters
Trigger Mode
INT
MAN
EXT
BUS
The list parameter used for the list measurement can be
the measurement frequency or the signal level [V/A].
Use the list point field to specify the list measurement
parameter.
To specify the list sweep measurement parameter
Step 1.
Press the [Measure] key.
Step 2.
Press the [LIST SETUP] soft-key.
Step 3.
Use the cursor key to select FREQ or VOLT
or CURR field.
Step 4.
Use the soft-keys to select list measurement
parameter.
Soft-key
FREQ
VOLT
CURR
LCR-6000 Series User Manual
Function
Trigger by the meter's internal trigger
source.
Trigger by pressing the trigger
button.
Trigger by sending a signal to the
trigger pin on the handler interface.
Trigger by the RS-232 port.
Function
Uses frequency as the list
measurement parameter
Uses voltage as the list measurement
parameter
Uses current as the list measurement
parameter
43