Cubicon Lux User Manual page 107

FREQuency Subsystem
The FREQuency command sets the oscillator frequency. The FREQuency?
query returns the current test frequency setting.
Figure ‎ 1 1-4
Command
Syntax
Parameter
Example
Query Syntax
Query Response
Example
Note
FREQ Subsystem Command Tree
FREQuency
FREQ[:CW] {<value>,MIN,MAX}
Where,
<value> Is the numeric data (NR1 integer, NR2fix float
or NR3 floating point).
MIN Sets to the minimum value
MAX Sets to the maximum value
SEND> FREQ 1K<NL>//Set to 1kHz,the Hz cannot
be added.
FREQ[:CW]?
<NR3><NL>
NR3 floating point
SEND> FREQ?<NL>
RET> 1.000000E+03<NL>
A suffix multiplier (k) can be used with this command.
But the suffix unit Hz can't be used.
This command CANNOT be used in LIST SWEEP
DISPLAY page and CORRECTION page.
[:CW]
{value,MIN,MAX}
LCR-6000 Series User Manual
103