List Subsystem; List:parameter; List:stat; Figure ‎ 1 1-9 List Subsystem Command Tree - Cubicon Lux User Manual

11.12 LIST Subsystem

The LIST or SWEEP Subsystem command group sets the List Sweep
measurement function, including the sweep point setting and limit values for
the limit function.
Figure ‎ 1 1-9
LIS T

11.12.1 LIST:PARAmeter

The LIST:PARAmeter command sets the list sweep parameter.
Command
Syntax
Parameter
Example
Query Syntax
Query Response
Example

11.12.2 LIST:STAT

The LIST:STAT command turns on/off the specified sweep point.
Command
Syntax
Parameter
Example
Query Syntax
LIST Subsystem Command Tree
:PARAmeter
:S TAT
:BAND
<n>,<value>,{A,B,OFF},<low>,<high>
LIST:PARAmeter {FREQ,VOLT,CURR}
Where, {FREQ,LEVEL} is:
FREQ Sets the sweep parameter to frequency
VOLT Sets the sweep parameter to voltage level
CURR Sets the sweep parameter to current level
SEND> LIST:PARA VOLT<NL>
LIST:PARAmeter?
{FREQ,VOLT,CURR}
SEND> LIST:PARA?<NL>
RET> FREQ<NL>
LIST:STAT <n>,{ON,OFF,1,0}
Where,<n> is:
n NR1(1 to 10): List sweep point
ON or 1 Set this point to ON
OFF or 0 Set this point to OFF
SEND> LIST:STAT 1,ON<NL>
LIST:STAT? <n>
LCR-6000 Series User Manual
{FREQ,VOLT,CURR}
<n>,{ON,OFF}
115