Table of Contents
Advertisement
11.14 TRIGger Subsystem
The TRIGger subsystem command group is used to enable a measurement or
a sweep measurement, and to set the trigger mode.
Figure 1 1-11
11.14.1 TRIGger[:IMMediate]
The TRIGger:IMMediate command causes the trigger to execute a
measurement or a sweep measurement, regardless of the trigger state.
Command
Syntax
Example
Note
11.14.2 TRIGger:SOURce
The TRIGger:SOURce command sets the trigger mode.
Command
Syntax
Parameter
Example
Query Syntax
Query Response
Example
11.14.3 TRIGger:DELAY
The TRIGger:DELAY command sets the trigger delay time.
Command
Syntax
TRIGger Subsystem Command Tree
[:IMMediate]
TRIGger
:S OURce
TRIGger[:IMMediate]
SEND> TRIG<NL>
This command can be ONLY used in BUS trigger mode.
TRIGger:SOURce {INT,MAN,EXT,BUS}
Where, {INT,MAN,EXT,BUS} is
INT
Internal Trigger Mode
MAN
Manual Trigger Mode
EXT
External Trigger Mode
BUS
BUS Trigger Mode
SEND> TRIG:SOUR BUS<NL>
TRIGger:SOURce?
{INT,MAN,EXT,BUS}
SEND> TRIG:SOUR?<NL>
RET>
INT<NL>
TRIGger:DELAY {<float>,min,max}
TRIGger:DLY {<float>,min,max}
LCR-6000 Series User Manual
{INT,MAN,EXT,BUS}
:DELAY(DLY)
<float value>,min,max
121
Advertisement
Table of Contents
