Environmental Requirements; Cleaning - Cubicon Lux User Manual

Note

1.2 Environmental Requirements

1.3 Cleaning

WARNING
12
If an abnormality is detected, contact the company and
transport the meter to your nearest GW INSTEK
Instruments sales or service office. Save the packing box,
shock-absorbing material, and packaged items as you
received them in case you need to mail the instrument to
an authorized GW Instek distributor or service center.
Set up the LCR-6000 Series where the following
environmental requirements are satisfied.
Operating Environment
Ensure that the operating environment meets the
following requirements:
Temperature:
Temperature range
at calibration:
Humidity:
Altitude:
To prevent electrical shock, disconnect the LCR-6000
Series power cable from the receptacle before cleaning.
Use a dry cloth or a cloth slightly dipped in water to clean
the casing. Do not attempt to clean the LCR-6000 Series
internally.
Don't Use Organic Solvents (such as alcohol or
gasoline) to clean the Instrument.
UNPACKING AND PREPERATION
0ºC to 50ºC
23ºC± 5ºC (<1ºC deviation from the
temperature when performing
calibration)
<70% at wet bulb temperature
≤40ºC (non-condensation)
0 to 2000m