Table of Contents
Advertisement
NOTE
6.1.3 KEY BEEP Setting
6.1.4 RS-232 baud rate
If you forget your password, please contact your local
GW Instek distributor or GWInstek at
www.gwinstek.com / marketing@goodwill.com.tw.
Key tone settings.
To set up the beep feature
Step 1.
Press the [Measure] or [Setup] key.
Step 2.
Press the [SYSTEM] bottom soft-key.
Step 3.
Use the cursor key to select the [KEY BEEP]
field.
Step 4.
Use the soft-keys to set the beep settings.
Soft-key
ON
OFF
Before you can control the LCR-6000 Series remotely via
the built-in RS-232 controller, you have to configure the
RS-232 baud rate.
The LCR-6000 built-in RS-232 interface uses the SCPI
language.
RS-232 configuration is as follows:
Data bits: 8-bit
Stop bits: 1-bit
Parity:
none
To set up the baud rate
Step 1.
Press the [Measure] or [Setup] key.
Step 2.
Press the [SYSTEM] bottom soft-key.
Step 3.
Use the cursor key to select the [BAUD] field.
Step 4.
Use the soft-keys to select the baud rate.
LCR-6000 Series User Manual
Function
Turn on the key beep feature.
Turn off the key beep feature.
71
Advertisement
Table of Contents
