Configuration Tasks For Ip Addresses; Assigning Ip Addresses To An Interface - Dell S6000–ON Configuration Manual

Hide thumbs Also See for S6000–ON:

Table of Contents

Configuration Tasks for IP Addresses

The following describes the tasks associated with IP address configuration.

Configuration tasks for IP addresses includes:

Configuring Static Routes

Configure Static Routes for the Management Interface

For a complete listing of all commands related to IP addressing, refer to the Dell Networking OS

Command Line Interface Reference Guide.

Assigning IP Addresses to an Interface

Assign primary and secondary IP addresses to physical or logical (for example, [virtual local area network

[VLAN] or port channel) interfaces to enable IP communication between the system and hosts connected

to that interface.

You can assign one primary address and up to 255 secondary IP addresses to each interface.

Enter the keyword interface then the type of interface and slot/port[/subport] information.

CONFIGURATION mode

interface slot/port[/subport]

For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/

subport information.

For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port

information.

For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

For the Management interface on the stack-unit, enter the keyword ManagementEthernet then

the slot/port information. The slot range is from 1 to 6. The port range is 1.

For a port channel interface, enter the keywords port-channel then a number.

For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Enable the interface.

INTERFACE mode

Configure a primary IP address and mask on the interface.

INTERFACE mode

ip address ip-address mask [secondary]

ip-address mask: the IP address must be in dotted decimal format (A.B.C.D). The mask must

be in slash prefix-length format (/24).

secondary: add the keyword secondary if the IP address is the interface's backup IP address.

You can configure up to eight secondary IP addresses.

IPv4 Routing