Peer active in peer-group outbound optimization
...
Configure BFD for VRRP
When using BFD with VRRP, the VRRP protocol registers with the BFD manager on the route processor module (RPM). BFD
sessions are established with all neighboring interfaces participating in VRRP. If a neighboring interface fails, the BFD agent on
the line card notifies the BFD manager, which in turn notifies the VRRP protocol that a link state change occurred.
Configuring BFD for VRRP is a three-step process:
1.
Enable BFD globally.
2.
Establish VRRP BFD sessions with all VRRP-participating neighbors.
3.
On the master router, establish a VRRP BFD sessions with the backup routers. Refer to
Neighbors.
Related Configuration Tasks
•
Changing VRRP Session
•
Disabling BFD for
VRRP.
Establishing Sessions with All VRRP Neighbors
BFD sessions can be established for all VRRP neighbors at once, or a session can be established with a particular neighbor.
Figure 16. Establishing Sessions with All VRRP Neighbors
To establish sessions with all VRRP neighbors, use the following command.
•
Establish sessions with all VRRP neighbors.
INTERFACE mode
vrrp bfd all-neighbors
Parameters.
Establishing Sessions with All VRRP
Bidirectional Forwarding Detection (BFD)
145