Ventilation Clearance Requirements - HP 8711C User Manual

W A R N I N G
深圳市盛腾仪器仪表有限公司
If this instrument is to be energized via an external autotransformer for
voltage reduction, make sure that its common terminal is connected to a
neutral (earthed pole) of the power supply.
5. Install the analyzer so that the detachable power cord is readily
identifiable and is easily reached by the operator. The detachable power
cord is the instrument disconnecting device. It disconnects the mains
circuits from the mains supply before other parts of the instrument.
The front panel switch is only a standby switch and not a LINE switch.
Alternatively, an externally installed switch or circuit breaker (which is
readily identiliable and is easily reached by the operator) may be used as a
disconnecting device.
6. Ensure there are at least two inches of clearance around the sides and
back of either the stand-alone analyzer or the system cabinet.
TWO
E D G E O F B E N C H
Figure l-3. Ventilation Clearance Requirements
Tel:0755-83589391
Step 2. Meet Electrical and Environmental Requirements
T W O I N C H C L E A R A N C E
Fax:0755-83539691
Installing the Analyzer
I
Website: www.Sengt.c