To Use Directory Utilities - HP 8711C User Manual

Using Instrument Functions
Saving and Recalling Measurement Results
This section describes how to make directories so you can store files into
categories, how to change between the various existing directories, and how
to remove an unwanted directory. You can make directories for floppy disks
and the analyzer's internal memory, and RAM disk.
Make a Directory
1. If you are going to use a floppy disk, place an MS-DOS formatted disk
3. Choose the location of the disk you want to make the directory on:
Remember that volatile RAM disk memory will be lost if the power to the
C A U T I O N
instrument is turned off.
4. Press File Utilities Dfrectory Utilities Make Dirsc$ary .
5. Enter the name of the new directory in one of the following ways:
4-72
深圳市盛腾仪器仪表有限公司
in the analyzer's built-in disk drive. If your disk is not formatted, refer
"Formatting a Floppy Disk" located later in this section.
Press
( ) Ssle~t
SAVE RECALL
internal non-volatile RAM disk, internal volatile RAM disk, or internal 3.5"
disk (the analyzer's built-in disk drive).
Think of a logical name to call a directory. Standard MS-DOS naming
conventions apply to the name of the directory (maximum of eight
characters plus a three character extension).
Use an external keyboard connected to the analyzer's rear panel DIN
l
KEYBOARD connector and type in the new hlename. (For information
on using a keyboard, see "Using a Keyboard" later in this chapter.)
Use the front panel knob and Sslett Gharacter key to point to and
l
select each character of the new directory name. Then press Enter .
Tel:0755-83589391
not
supported.
Fax:0755-83539691 Website: www.Sengt.co