HP 8711C User Manual page 285

Automating Measurements
Operator Interaction
Using User-Defined
When user-defined (BEGIN) is used in conjunction with a switch connected to
the USER TTL IN/OUT rear panel connector, you can cycle through up to
seven softkeys in sequence by activating the switch.
1. Connect a switch to the USER TTL IN/OUT rear panel connector as shown
2. Make sure the analyzer is configured to use the USER TTL
3. Press the switch several times while observing the analyzer.
4. Notice that with each press of the switch, the softkey labels are
7-28
深圳市盛腾仪器仪表有限公司
in Figure 7-6.
Figure 7-6. Connect a Switch to the USER TTL INlOUT Connector
IN/OUT connector for softkey sequencing: press
highlighted (boxed) in succession, and that after the last available key has
been used, the sequence starts again at the top of the softkey menu.
Tel:0755-83589391
(
SYSTEM OPTIONS
Fax:0755-83539691
)
Website: www.Sengt.co