Key Overview - HP 8711C User Manual

Selecting a New Device
Selecting a New
Measurement
深圳市盛腾仪器仪表有限公司
The IBEGIN_) key sets up a generic instrument state for the testing of various
types of devices.
The @FX') key has two different behaviors, depending on whether you are
new
selecting a device type, or a new
When you use the (BEGINI) key to select a new device type and measurement,
the analyzer does the following:
presets the analyzer (except for external reference parameters, and trigger
l
mode)
takes a sweep
l
autoscales the measurement
l
places a marker on the maximum or minimum point (depending on the
l
type of measurement)
makes the marker active
l
displays the AM delay connection diagram (when AM delay measurement is
l
chosen; Option 1DA or 1DB only)
l
See Table 3-l for a table of parameters for each measurement type.
Once you have selected your device, you can use the softkeys to select the
measurement you wish to make. When you select a new measurement, a
preset is not done. It is assumed that you are simply changing measurement
types and that you may have changed some of the analyzer's parameters
(such as frequency, power, etc.) for your DUT, and that you would not want
these parameters changed for subsequent measurements.
Tel:0755-83589391
Using the BEGIN Key to Make Measurements
measurement
type.
Fax:0755-83539691
Making Measurements
3-13
Website: www.Sengt.co