HP 8711C User Manual page 280

深圳市盛腾仪器仪表有限公司
Once you have selected a menu, the same menu will be displayed
for subsequent key presses of the @?%i] hardkey. (This is not true if
your IBASIC program has changed. If your program has changed, the
User BEGIN mode is reset to OFF)
By selecting
(
SYSTEM OPTIONS
rear panel connector. See "Using User-Defined [BEGIN) with a Switch, ' later
in this chapter for more information.
Selecting the User BEGIN softkey will run a macro function defined by a
sequence of IBASIC commands defined within an IBASIC program. IBASIC
programs to be used for User BEGIN must have the following structure:
!The following label must be present.
10
User-begin: !
2 0
. . .
3 0
! Define softkey labels
4 0
OUTPUT 087lX;"DISP:MENU2:KEYl 'Test Setup l';*WAI"
5 0
OUTPUT 087lX;"DISP:MENU2:KEY2
6 0
OUTPUT 0871X;"DISP:MENU2:KEY3 'Save Results';*WAI"
7 0
OUTPUT 087lX;"DISP:MENU2:KEY4
8 0
100 User-pause: PAUSE
110
!The following key labels must be present.
1 2 0
User,keyl: !Insert code for softkey 1 here
1 4 0
1 5 0
1 6 0
1 7 0
. . .
2 0 0
2 1 0
Tel:0755-83589391
System Conf$g Softkey Auto-Step
)
'Test Setup 2';*WAI"
'Print Results 4';*WAI"
Fax:0755-83539691
Automating Measurements
Operator Interaction
DO NOT REMOVE
DO NOT REMOVE
7-23
Website: www.Sengt.c