System Requirements; System Requirements And Minimum Equipment Levels For Time-Twin Digital - Fronius TimeTwin Digital Operating Instructions Manual

System requirements

System require-
(1)
ments and mini-
mum equipment
levels for Time-
Twin Digital
(2)
Welding torch
1 x Robacta Twin 500 or
1 x Robacta Twin 900
Torch hosepack
1 x Robacta Twin hosepack or
1 x Robacta Drive Twin hosepack
- with the Robacta Drive Twin original equipment package for the wire
diameter in question
- with the optional "PMR 4000 PullMig installation kit" installed on bo-
th wirefeeders
- with the "Enhanced motor supply" option installed on the power
sources in cases where any of the following wirefeeders are being
used: VR 1500-11, VR 1500-30, VR 7000-11 and VR 7000-30
(1)
(2)
(6)
(3) Wirefeeders
2 x VR 7000 (+ variants) or
2 x VR 1500 (+ variants)
(4) Intetconnecting cable
2 x standard-interconnecting
cables
(5) Power sources
2 x TPS 4000 (+ variants) or
2 x TPS 5000 (+ variants)
- with official firmware UST
V3.10.33 and above
- with "LHSB link" option
- with the software enabled
for "TimeTwin Digital"
- with a software update
from the Fronius databank
- with robot interface (stan-
(3)
dard I/O or field bus)
These options are required (i.e.
(4)
mandatory) when using a TPS
4000 and/or TPS 5000, in each
(5)
case on both power sources. 1 x
LHSB connector cable´
(6) 1 x LHSB connector cable
(7) Cooling units
1 x cooling unit FK 9000 R oder
2 x cooling unit FK 4000 R
-
(7) with optional rate-of-flow
watchdog or
2 x FK 4000 R US (cooling units
(for USA)
69