System Calibration - Fronius TPS 320i Operating Instructions Manual

How it works:
Once the torch trigger is pressed, gas pre-flow begins immediately. Wirefeeding then be-
gins, followed by ignition. If no current starts flowing before the specified length of wire
has been fed, the power source cuts out automatically.
To try again, press the torch trigger again.
System calibra- If two motors are used in a welding system, they need to be calibrated to maintain process
tion stability.
System calibration must be carried out on welding systems with PushPull units or unreeling
wirefeeders following successful installation or replacement of a wirefeeder.
A notification will be displayed.
1
The system calibration wizard starts.
2
System calibration can also be started manually here.
Perform system calibration:
1
2
An overview of the process parameters for components and monitoring is displayed:
118
Select "OK" and start system calibration
Follow the instructions shown
1
Select "Process parameters"
Select "Components & Monitoring"
2