Table of Contents
Advertisement
Commissioning
Checking the
connections
The following activities and work steps apply to the installed system. All connections
must be established. Before start-up, check the connections of the following system
components:
-
-
-
-
-
-
Precise information on the assembly and connection of the system components can be
found in the relevant system component operating instructions.
Switching on
IMPORTANT! There are no fixed rules for the sequence in which the system
system
components are switched on. They can be switched on in any order.
components
Switch the main switch on the following system components to the
"ON - 1" position:
-
-
-
Defining carriage
Determine the following settings for the welding process:
parameters
-
-
-
Further information and a detailed description of the carriage parameters can be found in
the operating instructions for the FRC-40 remote control.
Selecting and
IMPORTANT! For each workpiece a corresponding welding program must be created.
loading the
This contains a list of welding parameters that is saved under a specific program number
welding program
(job number). These programs can be reloaded at any time, and corrected as required.
The programs are managed from the FRC 40 remote control.
Load the relevant welding program.
More detailed information on "Managing welding programs" can be found in the
operating instructions for the FRC 40 remote control.
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described here until you have thoroughly
read and understood the following documents:
-
These operating instructions
-
All the operating instructions for the system components, especially the
safety rules
Power source
Cooling circuit
Gas cylinder
Wire-feed unit
Welding torch with hosepack
Workpiece
Carriage control unit
Power source
Wire-feed unit (if power is not supplied from the power source)
Traversing speed
Path
Select the correct welding program
12
Advertisement
Table of Contents
