Process Parameters - Fronius TPS 320i Operating Instructions Manual

Process parameters

Overview The "Process parameters" menu button contains the following selection options:
-
-
-
-
-
Process parame- The following parameters can be set and displayed for the start and end of welding:
ters for start of
welding / end of
Starting current
welding
for setting the starting current for MIG/MAG welding (e.g. aluminium welding start-up)
Unit
Setting range
Factory setting
Start arc length correction
for correcting the arc length at the start of welding
Unit
Setting range
Factory setting
-
0
+
Slope 1
for setting the time during which the starting current is decreased or increased to the
welding current
68
Start of welding / end of welding
Gas setup
Process control
R/L alignment
Components
% (of welding current)
0 - 200
135
% (of welding voltage)
-10 - +10
0
shorter arc length
neutral arc length
longer arc length