Welding Parameter Standard Values; Alignment Of Welding Torch Relative To The Workpiece For Fillet Welds; Alignment Of Welding Torch Relative To The Workpiece For Lap Joints - Fronius Drive EasyTwin Operating Instructions Manual

Welding parameter standard values

Alignment of
welding torch rel-
ative to the work-
piece for fillet
welds
Side view of welding torch/workpiece
Alignment of
welding torch rel-
ative to the work-
piece for lap
joints
Side view of welding torch/workpiece
If notches appear in the weld seam on the top sheet, adopting the welding torch
alignment shown below can prevent these notches from occurring.
34
(1)
35 - 40°
(2)
(1)
55 - 75°
NOTE!
- Align welding torch (1) relative to the
workpiece (2) as shown on the left-
hand figure
- Welding torch (1) at a 5° angle to the
welding direction
- Align welding torch (1) relative to the
workpiece (2) as shown on the left-
hand figure
- Welding torch (1) at a 5° angle to the
(2) welding direction